Advanced Rigging

*** COURSE LOCATION AND ADDRESS WILL BE IN THE CONFIRMATION EMAIL. CHECK YOUR EMAIL IF YOU REGISTER FOR A COURSE. IF YOU DO NOT RECEIVE A CONFIRMATION EMAIL WITHIN 48HRS OF REGISTRATION, CALL THE TRAINING CENTRE TO CONFIRM LOCATION. SHOWING UP AT THE WRONG LOCATION WILL RESULT IN A $150 NO SHOW FEE. ***

PLEASE READ YOUR CONFIRMATION EMAIL FOR THE LOCATION AND ADDRESS OF YOUR COURSE.

ACTC Course Location ID:

EARIG - Alberta Carpenters Training Centre (Edmonton) 176, 15210-123 Avenue NW

CARIG - Alberta Carpenters Training Centre (Calgary) 10, 1305-33 Street NE

Approved Safety Training Provider, ACTI, Course Location ID:

ECWARIG - ACTI’s New Office (Centre West, Edmonton) 12118 154 Street NW

EEIARIG - Electrical Industry Training Centre (Edmonton) 4234-93 Street

CANCELLATION POLICY:

Once you receive a confirmation email from the ACTC, you are considered registered. To cancel you must call or leave a message 48 hours in advance at (780) 455-6532 Ext. 4242 or by replying to your confirmation email to avoid a NO SHOW FEE of $150.00.

Please arrive between 7:30 a.m. and 7:45 a.m. for sign-in.

Class starts at 7:45 a.m. SHARP

Member Registration Fee Is $39.00

Class Requirements:

Photo ID

$39.00 Registration Fee - DUE MORNING OF THE COURSE

Required Attire:

CSA Steel Toed Boots

Gloves

No Dresses Or Skirts (Must complete full inspection)

*********************************************************************

Advanced Rigging Course Consists Of:

·       In class presentation

·       Theory final exam

·       Hands on practical including Rigging hardware inspection, sling capacity, demonstrating hand signals and multiple lift demonstrations (with the Crane)

Topics Covered:

·       Legislation & Standards

·       Load weight and calculations

·       Sling angle stresses

·       Centre of gravity

·       Sling hitches and types

·       Below the hook lifting devices

·       Crane communication

While this basic course can be used as part of a worker's competency assessment, the employer must designate a worker as a "competent person" based on specific tasks assigned.

No Upcoming Courses Scheduled